Saitek X55 Rhino

Evening All,

I recently picked up a Saitek x55 for use with WCS. It connects to the PC with two USB ports and subsequently registers with the machine as TWO devices, the stick, and the throttle; separately. This is different from older devices in this line. Previous models, like the X52, registered on the PC as a single device. No problem.

The WCS launcher control tab allows the enabling of one control device. Meaning you can enable the program to accept input from either the stick OR the throttle quadrant, not both.

Bottom line is that it just doesn't see the second device. No buttons, no axis inputs.

Normally I'd just enable the stick in WCS and map the rest with the 3rd party (Saitek) software, but mapping throttle axis' to keypresses is....imprecise.

Any idea how to get the WCS Launcher control tab to accept both devices at the same time?